Page 52 - Urban Jungle mode d'emploi_EN_HD

Adjustment of handlebar tilt and brake levers on URBAN JUNGLE city, trek- king, urban and kids’ bikes
The handlebars are usually slightly bent at the ends. Set the handlebars to a position in which your wrists are relaxed and not turned outwards too much (d).
Release the Allen bolt(s) at the bottom or front side of the stem. Turn the handlebars to the desired position.
Make sure the handlebars are accurately centreed in the stem. Carefully retighten the bolt(s) with the torque wrench. Make sure the upper and lower clamping slots of the stem are parallel and identical in width (e).
Tighten the bolts evenly and in a cross pattern (f), i.e. alternately and gradually, to the lower value of the recommended torque values using a torque wrench.
Once clamped in the stem try rotating the handlebars and tighten the bolt a little more, if necessary. Use a torque wrench and never exceed the maximum torque values! You find them directly on the components and/or in the manuals of the component manufacturers. If the handlebars are not tight with the prescribed torque value, use carbon assembly paste.
After adjusting the handlebars you need to adjust the brake lever/shifter units. Release the Allen bolt at either unit. Turn the levers relative to the handlebars. Sit in the saddle and place your fingers on the brake levers.
d
e
f
| 52 | ORIGINAL OPERATING INSTRUCTIONS