Page 46 - Urban Jungle mode d'emploi_EN_HD
P. 46
If you want to turn the stem around, you have to also release the bolts of the faceplate secu- ring the handlebars (d). If the stem is tted with a cap, you can simply take out the handlebars at this point. If it is not fitted with a cap, you have to remove the handlebar fittings.
Mount the handlebars and, if necessary, the handlebar fittings, as described in the chapter «Adjustment of handlebar tilt and brake levers» and/or in the manuals of the component manufacturers.
Check after the adjustment or assembly, whether the handlebars are firmly seated in the stem by trying to rotate the handlebars downwards (e). Verify whether the handlebar/stem-com- bination can be turned relative to the fork. Do this by taking the front wheel between your knees and trying to twist the handlebars.
If there is movement, carefully tighten the bolts a little more by using the torque wrench, observe the maximum torque value and check again the proper fit (f).
Tighten carefully by approaching the prescribed maximum torque value in small steps (0.5 Nm increments) and check in between the proper fit of the component. Never exceed the maxi- mum torque value indicated by URBAN JUNGLE!
Ask your URBAN JUNGLE dealer to explain you both function and adjustment of your stem or, still better, let him do that work.
WARNING
In the case of turned stems, it is possible that the cables are too short. In this case riding can be unsafe. If in doubt, ask your URBAN JUNGLE dealer.
NOTICE
When removing spacers the fork steerer tube must be shortened. This change is irrever- sible. The shortening should be carried out by your URBAN JUNGLE dealer, but only after you have found your preferred position.
SAFETY INSTRUCTIONS
Keep in mind that readjusting the position of the stem changes the position of handle- bars, brake levers and shifters. Readjust these components, as described in the chapter «Adjustment of handlebar tilt and brake levers“.
d
e
f
| 46 | ORIGINAL OPERATING INSTRUCTIONS