Page 43 - Urban Jungle mode d'emploi_EN_HD

WARNING
If you choose to use the product of another manufacturer, make sure it is compatible with the URBAN JUNGLE/SYNCROS components. URBAN JUNGLE assumes no responsibility for problems resulting from the use of non-URBAN JUNGLE/SYNCROS products. Make sure the handlebar/stem-combination is approved by the handlebar and/or stem manufacturer.
Make sure the handlebar clamping area is free of sharp edges.
Stems - conventional
Handlebars with conventional stems allow limited vertical adjustment. This is done by moving the stem up or down inside the fork steerer tube (a).
Release the expander bolt by two to three complete turns. The stem should now turn freely inside the fork. If it does not, release the bolt by tapping it gently with a rubber hammer (b). With Allen bolts, you need to stick the Allen key into its head first, as it is normally counter- sunk and therefore impossible to be hit directly.
Now you can move the handlebar/stem-unit up and down as a whole. Be sure not to pull out the stem too far. The mark on the stem (end, min, max, stop, limit or the like) should always remain within the tube. Setting the stem to a lower position can only add to your safety!
Realign the handlebars with the front wheel (c). Make sure the front wheel is in alignment with the handlebars and the stem. Retighten the expander bolt with a torque wrench.
Tighten carefully by approaching the prescribed maximum torque value in small steps (0.5 Nm increments) and check in between the proper fit of the component. Never exceed the maximum torque value indicated by the manufacturer! You will find the prescribed values in the chapter «Recommended torque settings for your URBAN JUNGLE bike», directly on the components and/or in the manuals of the component manufacturers.
a
b
c
ORIGINAL OPERATING INSTRUCTIONS | 43 |